top of page

CPAP MASK CLEANING

DisassemblY OF CPAP MAsK

ResMed AirMini CPAP Mask Cleaning:

​

For N20 Mask users

​

  1. Disconnect the connector from the mask by pressing on its side buttons and pulling away.

  2. Disconnect the vent module from the AirMini tubing by twisting them away from each other.

  3. Disconnect the vent module from the mask tube by twisting them away from each other.

  4. If HumidX or HumidX Plus was used, remove it from the vent module.

​

For F20 Mask users

  1. Disconnect the connector from the mask by pressing on its side buttons and pulling away.

  2. Disconnect the F20 connector from the AirMini tubing by twisting them away from each other. 

​

For P10 Mask users

  1. Disconnect the vent module from the AirMini tubing by twisting them away from each other.

  2. Disconnect the vent module from the mask tube by twisting them away from each other.

  3. If HumidX or HumidX Plus was used, remove it from the vent module.

 

ResMed AirMini

  1. Disconnect the AirMini tubing by pressing on the side of the grey cuff and pulling away.

  2. Unplug the power supply unit from the power outlet and the machine.

Daily cleaning OF CPAP MASK

For N20 Mask users
Note: Do not wash or wet the HumidX / HumidX Plus. When not in use, store in a clean and dry place.

 

  1. Clean and check the N20 connector by hand daily. Never wash it using a dishwasher or washing machine.

  2. Remove the HumidX before proceeding with cleaning.

  3. Wash the connector in warm water (~30°C or 86°F) and mild liquid detergent.

  4. Clean the connector using a soft bristle brush, with particular attention paid to the vent holes on the inside.

  5. Rinse well under running water, and then shake to remove excess water.

  6. Air dry out of direct sunlight, and check for dirt or dust before use.

 

For F20 Mask users

 

  1. Clean and check the F20 connector by hand daily. Never wash it using a dishwasher or washing machine.

  2. Wash the connector in warm water (~30°C or 86°F) and mild liquid detergent.

  3. Clean the connector using a soft bristle brush, with particular attention paid to the vent holes on the outside.

  4. Rinse well under running water, and then shake to remove excess water.

  5. Air dry out of direct sunlight, and check for dirt or dust before use.

Weekly cleaning

ResMed AirMini tubing

 

  1. Clean and check the AirMini tubing by hand weekly. Never wash it in a dishwasher or washing machine.

  2. Separate tubing from AcitveAir vent connector.

  3. Soak and wash the tubing in warm water (~30°C or 86°F) and mild liquid detergent.

  4. Rinse well inside and out under running water.

  5. Hang the tubing so that each end can drain, and leave it to air dry out of direct sunlight.

  6. Clean the AirMini by wiping down each side of its exterior carefully with a dry cloth.

bottom of page